![]() ![]() You will need to add a 1k resistor between D49 and D41 which are both on the 10-pin header. The ST4 pins including that used for the hand-controller are present on the lower 10-pin IDC header on the right hand side of the board. ![]() #define resetPin_1_Define 37 //Unused on RAMPS #define resetPin_0_Define 35 //Unused on RAMPS #define gpioPin_2_Define 41 //IO2 - GPIO Pin #define gpioPin_1_Define 33 //IO1 - GPIO Pin #define gpioPin_0_Define 49 //IO0 - GPIO Pin I can help betatest this if you are doing the change. #define Axis2_M0 31 // Pin 31 (Microstep Mode 0 or SPI MOSI) #define Axis2_M1 33 // Pin 33 (Microstep Mode 1 or SPI SCK) #define Axis2_M2 35 // Pin 35 (Microstep Mode 2 or SPI CS) #define Axis2_Aux Aux2 // Pin 37 (ESP8266 RST or SPI MISO) #define Axis2_HOME 21 // Pin 21 (Home sw) #define Axis1_M0 23 // Pin 23 (Microstep Mode 0 or SPI MOSI) #define Axis1_M1 25 // Pin 25 (Microstep Mode 1 or SPI SCK) #define Axis1_M2 27 // Pin 27 (Microstep Mode 2 or SPI CS) #define Axis1_Aux Aux1 // Pin 29 (ESP8266 GPIO0 or SPI MISO) #define Axis1_HOME 20 // Pin 20 (Home sw) This is the pinmap used by another TC project: The datasheet for the MKS Gen L is here: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |